| Product ID: VSGF28NTF |
|
 Vanguard Classic Hearth Vent-free Gas Fireplace - Thermostat Controlled with blower and Split Oak Logs. Uses Natural Gas
|
|
| This fireplace has a blower assembly. The blower operates
thermostatically and has a variable speed control. The blower circulates
heated air from the fireplace into the room. Use of blower is optional.
THERMOSTAT CONTROL
This fireplace has a thermostat sensing bulb and a control valve. The
thermostat controls the heat output and flame height. This maintains a
consistent room temperature. Even the lowest setting provides realistic
flames and glowing embers from two burners. Selecting higher comfort
settings allows fireplace to run longer, producing greater heat output. At
lower comfort settings, the fireplace will run less. This results in
increased heating comfort. This can also result in lower gas bills.
Because this fireplace has a blower assembly with a 5 foot long electrical cord, you must locate fireplace within
reach of a 120-volt grounded electrical outlet. If not, you must install
an electrical outlet within reach of fireplace power cord. The GA3555
outlet accessory may be used for built-in installation when a blower
is installed. |
|
|
|
| |
